Products — CPCI and CPCIe — Backplanes

Products > CPCI/CPCIe > Accessories > Extender card

Extender card

Hot swap extender supports both 32 and 64 bit transfers.

Form Factor: 3U
Part Number: OSS-CPCI-3U-EXT-HS

Product Features

Board Length: 7.75
Swap UUT without having to turn the PC power Off and On
Full height, 7.75 inches
3.3V <=> 5V signal translator
On-board 3.3V regulator.
On-board power-on reset
On-board LED indicators

The CPCI-64 Hot Swap Extender, can be used in any 3U 32 or 64-bit CompactPCI compatible systems. This Hot Swap Extender is designed to isolate all the voltages and the signals between the CompactPCI motherboard and the UUT, while the system power stays on. This isolation can be accomplished by either using the on-board mechanical On-Off switch or via remote control. This feature eliminates the requirement for power cycling the system and repeated rebooting during the test and characterization process. The CPCI-64 Hot Swap Extender expedites the test and characterization as well as reducing the chance of the system failure due to repeated power cycling.

Specifications

Bus	CPCI-64, Compact PCI, 5V or 3V, 32 or 64-bit.
Input Voltage Requirements	+5V @ 200 mA, +12V & -12V @ 50 mA for each voltage at no load.
Output Ratings	+5V, Jumper selectable to 5 Amp or 1 Amp limit.
	+3.3V at 2.5 Amp.
	+/- 12V at 1 Amp.
Output Voltage Drop	50 mV drop for every 1 Amp drawn for +5V, +3.3V and +VIO.
	30 mV drop for every 1 Amp drawn for -12V.
	30 mV drop for every 100 mV drawn for +12V.
Propagations Delay	Less than a nanosecond from the motherboard to the UUT.
On-Off Controls	Mechanical SPST switch, or an I/O remote interface.
Outputs	J3.2 =%V current measurement, each Volt represents 1 Amp.
	J3.3 +12V current measurement, each Volt represents 1 Amp.
	J3.4 +3.3V current measurements, each Volt represents 1 Amp.
	JA – JF All Compact PCI signals.
Mechanical Dimensions	Height = 7.75 inches (197 mm).