| Ethernet Interface |
two channels |
| |
supports 10BaseT,100BaseTx and 1000BaseT for
UTP CAT5 via RJ45 connectors on front panel |
| |
Ethernet signals are routed via transition
module’s front panel or via PICMG® 2.16 Packet
Switching Backplane |
| |
EIDE INTERFACE:|supports Ultra-DMA 33 speeds
via 40-way header |
| |
option for CompactFlash/IBM Microdrive connector
or 1.8 inch disk drive fitted |
| Serial Interface |
RJ45 connectors for 2 x RS232 asynchronous
serial ports:-each channel supports TXD, RXD, RTS, CTS, DTR,
DSR and DCD controlled via Low Pin Count (LPC) bus |
| USB Interface |
1 x USB channel accessed via USB connector
on front panel |
| Parallel Printer Port |
via 26-way header on-board |
| |
supports all common modes of operation (for
example, EPP, ECP) |
| |
controlled via LPC bus |
| Floppy Disk Interface |
via 34-way header on board |
| |
controlled via LPC bus |
| PMC I/O |
2 x 68-way high density D-type connectors
on the front panel |
| |
Vertical on-board 68-way high density D-type
connectors |
| |
each connector provides 64-bits of I/O from
one PMC site |
| |
wiring compatible with Concurrent Technologies
PMC SCSI modules |
| Other Interfaces |
PC speaker via 5-way header |
| |
10-way header providing:-system fan monitor |
| |
external reset |
| |
general purpose user I/O lines (GP I/O) |
| Electrical Specification |
all voltages to be within ±5% |
| |
5V@0.2A — quiescent current; +3.3V@0.2A |
| Environmental Specification |
0°C to +55°C (operating) |
| |
-40°C to +70°C (storage) |
| |
10% to 90% Relative Humidity, non-condensing
(operating) |
| |
10% to 90% Relative Humidity, non-condensing
(storage) |
| Mechanical Specification |
6U form-factor: 9.2" x 3.2" (233.35mm
x 80mm) |
| |
single-slot: 0.8" (20.3mm) |
| |
connectors: IEC-1076-4-101 for J3 and J5 |
| |
shock:20g, 11ms, ½ sine (operating); |
| |
30g, 11ms, ½ sine (non-operating) |
| |
vibration:5Hz-2000Hz at 2g, 0.38mm peak displacement
(operating);5Hz-2000Hz at 5g, 0.76mm peak displacement (non-operating) |
