| Central Processor |
1.1 GHz Intel® Pentium® M
processor:
:: uses mFC-BGA 479 (micro Flip-Chip Ball Grid Array) package
:: 64 Kbytes of primary (Level 1) on-die cache
:: 1 Mbyte of secondary (Level 2) on-die cache
:: 400 MHz Front Side Bus (FSB)
No CPU fan; 0.13 micron low power processor
Utilizes 64-bit ServerWorks’ GC-LE chipset
Provision for ITP debug port |
| DRAM |
Supporting up to 2 Gbytes DDR ECC SDRAM:
:: up to 2 Gbytes provided via two SODIMM sockets
:: error correction up to 4-bits
Accessible from Intel Pentium M processor or CompactPCI bus |
| Hard Disk Interfaces |
EIDE interface:
:: supports up to Ultra-DMA 100 for high performance drives
:: two channels (primary and secondary)
:: primary channel is accessible via Transition Module
Secondary channel can be used for on-board dual CompactFlash
module |
| Ethernet Interface |
Implemented by Intel 82546EB LAN Controller
via 64-bit PCI bus
two channels supporting 10 Base-T, 100 Base-TX, 1000 Base-T:
:: support for PICMG 2.16 R1.0 — Packet Switching Backplane
(PSB)
:: optional support for rear panel RJ45’s via Transition
Module
One channel switchable to front panel RJ45, supports 10Base-T,
100Base-Tx and 1000Base-T |
| Graphics Interface |
Implemented by a Silicon Motion SM722 providing:
:: 8 Mbytes video memory
:: resolutions up to 1280 x 1024; supporting up to 16M colors
Accessed via a 26-way high-density connector on front panel |
| PMC (PCI Mezzanine Card) Interface |
2 x PMC sites; for both sites:
:: I/O via front panel
:: I/O via J3 and J5
:: 32/64-bit, 33/66 MHz PCI operation
:: 3.3V or 5V signaling levels
Transition Module provides rear I/O for both PMC sites |
| Serial Interface |
Up to 3 x RS232 serial channels:
:: 1 channel via a 26-way high-density connector on front
panel
:: either 1 channel via J5 or 2 channels via optional Transition
Module
16550 compatible UART
Channels support RI, CTS, RTS, DSR, DTR and DCD |
| Flash Eprom |
32 Mbytes of Application Flash EPROM — 8-bits
wide
512 Kbytes of BIOS Flash EPROM — 8-bits wide |
| Firmware Support |
Phoenix ServerBIOS
Comprehensive Power-On Self-Test (POST)
LAN boot firmware included |
| Software Support |
Support for VxWorks, Windows NT, Windows 2000,
Windows XP, Windows XP Embedded, Linux and QNX |
| Other Peripheral Interfaces |
Keyboard and mouse interfaces accessed via
a 26-way high-density connector on front panel
PC-compatible Real Time Clock (Year 2000 compliant)
Watchdog timer system fan monitor; CPU temperature monitor;
voltages monitor:
:: all accessible via IPMI
Speaker interface
1 x USB (Universal Serial Bus) interface via J5 Transition
Module
1 x 32-bit Long Duration Timer with processor interrupt capability
LPC (Low Pin Count) bus via J5 to enable the AD PP5/001 Transition
Module support for:
:: floppy disk interface
:: parallel printer port interface (ECP, EPP and IEEE1284)
:: 2 x RS232 serial channels |
| CompactPCI Interface |
Compliant with PICMG 2.0 R3.0; 3.3V or 5V
signaling levels:
:: universal signaling support
33/66 MHz; 32/64-bit interface accessed via J1/J2 connectors
Utilizing a PCI-PCI bridge for off-board accesses
Operates as a System Slot controller or in a Peripheral slot
PICMG 2.1 R2.0 Hot Swap Specification compatible
Option to disable CompactPCI interface (Satellite Mode):
:: receives power from CompactPCI bus board can be hot swapped
in this mode
:: J4 connector not fitted |
| IPMI (Intelligent Platform Management
Interface) |
PICMG 2.9 R1.0 (System Management Specification)
Implements the IPMB0 interface on-board BMC (Baseboard Management
Controller)
Supports 8 Kbytes of non-volatile memory |
| Electrical Specification |
+5V@2.0A (typical at 1.1 GHz with 512 Mbytes
DRAM); +5% / -3%
+3.3V@6.5A; +5% / -3%;
+12V@0.010A; -12V@0.010A;
+12V and -12V routed to PMC expansion slots
|
| Safety |
PCB (PWB) manufactured with flammability rating
of 94V-0 |
| Environmetal Specification |
-25°C to +70°C (operating); for commercial
temperature see PP 310/01x;
10% to 90% Relative Humidity, non-condensing (operating);
-40°C to +70°C (storage) 10% to 90% Relative Humidity,
non-condensing (storage);
Operation over ambient temperature range:
:: -E: -25°C to +70°C |
| Mechanical Specification |
6U form-factor: 9.2inches x 6.3inches (233mm
x 160mm);
single-slot: 0.8inches (20.3mm);
connectors: IEC-1076-4-101 for J1-J5
shock:
:: 20g, 11ms, ½ sine
:: 30g, 11ms, ½ sine (non-operating)
Vibration:
:: 5Hz-2000Hz at 2g, 0.38mm peak displacement (operating)
:: 5Hz-2000Hz at 5g, 0.76mm peak displacement (non-operating) |
